Φίλε γειά σου
Απο αναζήτηση στο διαδίκτυο μάλλον (αν κατάλαβα καλά) πρέπει κοντά στον κινητήρα να έχει έναν συμπέκτη που ρυθμίζει τις στροφές στο μοτέρ (κόκκινα γράμματα).Αυτό ίσως θέλει καθάρισμα ή αλλαγή γιατί υπερθερμένει το μοτέρ και έτσι σταματά.Αν ξέρεις καλά αγγλικά σου παραθέτω αυτούσιο το κείμενο και την διεύθυνση...
Ελπίζω να σε βοήθησα και να μην σε μπέρδεψα με ανοησίες.Πάντως το πρόβλημα απο την πρώτη ώρα μου φαινόταν μηχανικό και όχι ηλεκτρολογικό εφ' όσον το μοτέρ γυρνα εξ αρχής και κατά δεύτερον έχεις σταδιακή πτώση στην ισχύ (τάση Οκ και ρεύματα Οκ).
Υ.Γ
Υπάρχει και ένας διακόπτης υπερφόρτωσης κατά τα λεγόμενά του που σταματά την λειτουργία του μοτέρ (πράσινα γράμματα)
I had the same problem. The machine will do the washing cycle. At the start of the spin cycle it would start turning with a lot of clicking sounds and then would stop spinning. The water pump would continue working without problem. The motor tries to start again in about three minutes, however, repeats the same behavior. I have a reasonable mechanical and electrical knowledge. I was sure that the overload protection switch of the motor was tripping. I opened up my machine---a GE super capacity top loading machine. Took off the belt and turned the transmission pulley. It turned easily in both directions (washing and spinning). Hence, the transmission was good. Next, I checked any water accumulation in the spin tub. If the water is not drained properly before the spin cycle, it would overload the motor. There was no water clogged in the spin tub. Finally, I dismantled the electric motor. There was a clutch assembly underneath the motor pulley. I dismantled it and found the clutch very dirty with some grease that had turned sticky. I cleaned the assembly thoroughly with alcohol and assembled back the machine. The machine is running perfect after that. Conclusion: The clutch assembly was mis-functioning. Reason: When the spin cycle starts, the spin tub is very heavy and cannot achieve the full speed quickly. On the other hand, electric motors must get to their running speed fairly quickly or else overheating of motor would happen. A proper functioning clutch allows the motor to run at their optimal speed while transferring enough torque to the spin tub to slowly speed up the tub to its fullest. In my case, the clutch was sticky, thus overloading the motor which would trip as it overheats.
http://www.fixya.com/support/t480272...ine_stop_stars
Απάντηση με παράθεση
Αρχικό μήνυμα από liontas
