Και μια βοηθεια ακομα 7 Service Mode Settings
Only if the appliance is in waiting mode, entering the service mode is done by pressing simultaneous
two push buttons, then switching on the machine and wait for 4sec.
On EDW1xxx-2GΒ΄s user interfaces : Pressing buttons S1+S3.
On EDW3xxx connected user interfaces : Pressing buttons S1+S3 (EDW2500) or S3+S4 (EDW2503).
Service mode is left by switching off the appliance or after a 60sec time out.
Activated mode is indicated by the LEDs related to the buttons S1, S2 and S3.
7.1 Alarm Code Reading and Single Load Activation
If entered the service mode, the single load activation is selected by pressing the S1.
Each time pressing S1 moves to the next actuator to activate.
After controlling the last in list it will switch back to the first.
The sequence of the actuators is defined like that:
1. Alarm code 1
2. Alarm code 2
3. Alarm code 3
4. Regeneration valve
5. Drain pump
6. Inlet valve
7. Heating (if the level of water is reached)
8. Circulating with 2800rpm
9. Dispenser
10. Fan
If a display is available, the actual test step will be indicated by its number (starting with 4.)
7.2 LED Test and Reset Alarm Memory
If entered the service mode, the line test program is selected by pressing the button S2.
All indication LED’s are flashing 30sec. Alarm code memory is cleared.
7.3 Line test program
If entered the service mode the line test program is selected by pressing the button S3. The line test program
starts immediately.
SOI/TD 2009/12 10 599 72 48-93
The running line test program is displayed by a flashing LED related to the button S3 and it takes 15
minutes.
After finishing the line test the LED related to the button S3 is switched off and the LED end will be activated
and the remaining time displays 0 respectively.
7.4